毕业论文

打赏
当前位置: 毕业论文 > 电子通信 >

基于Matlab空心线圈积分电路设计+文献综述

时间:2017-05-06 11:03来源:毕业论文
利用在 Simulink 环境下搭建电路模型的方法进行仿真,在加入运放失调电压等干扰信号的条件下,对比了Rogowski线圈用电压并联型负反馈积分器和新型积分点路对电路故障暂态信号的跟踪

摘要电流互感器的输出信号是对一次侧电流的微分,为还原一次侧电流信号,需对输出端添加积分电路。积分电路的参数选取直接影响调理信号的真实程度。本文在分析积分器特性的基础上,设计了一种Rogowski 线圈用新型积分电路。该电路利用电压串联型负反馈放大电路正向输入阻抗大的优点,结合减法器原理,通过分别对信号,对地积分后二级相减的方式,达到理想积分,消除零漂效果。利用在 Simulink 环境下搭建电路模型的方法进行仿真,在加入运放失调电压等干扰信号的条件下,对比了Rogowski线圈用电压并联型负反馈积分器和新型积分点路对电路故障暂态信号的跟踪效果,结果表明,新型积分器能够真实的反映故障电流、暂态电流并且有效抑制积分器零漂对传感元件的干扰。
关键词:Rogowski线圈 变化电流 电流传感器  积分电路  Simulink 环境8201
Title       Integral circuit design of hollow coil based on matlab   
Abstract
The output signal  of hollow current transformer is the differential of primary current
signals, in order to effectively restore primary side current signal, we usually need to
add a integral circuit to  the output side. The parameter selection of integral circuit  
directly influence the true extent of conditioning signal, so the right parameter is the
guarantee of follow-up relay protection equipment. This article design a kind of new
type Rogowski coil with integral circuit based on analyzes of integrator characteristics.
It is a kind of voltage series type negative feedback amplifying circuit with big positive
input impedance. With  building circuit model in Simulink environment to simulate,
This article show that this new integrator can reflect the real fault current and transient
current and effectively restrain the interference of the zero shift integrator of sensor.  
 Keywords:   Rogowski coil,mutative current,current sensor,integrating circuit,
Simulink 目    次
1   引言1
1.1   Rogowski 线圈结构与特点1
1.2   关于罗氏线圈的积分电路1
1.2.1  影响罗氏线圈测量准确度的因素1
1.2.2  典型的外积分电路2
1.2.3   Rogowski  线圈带电压负反馈模拟积分器2
1.2.4  新型积分电路3
2   基于运放的受控源设计及仿真4
2.1   运算放大器的结构与特点4
2.1.1   运算放大器的电路符号4
2.1.2   运算放大器的工作电源4
2.1.3   理想运放模型4
2.1.4  Simulink 仿真中运算放大器的建模5
2.2   四种受控源的基本电路7
2.2.1  电压控制电压源8
2.2.2  电压控制电流源9
2.2.3   电流控制电压源10
2.2.4   电流控制电流源11
3   基于运放的基本运算电路13
3.1   加法电路13
3.2    减法电路14
3.3   比例电路17
3.4    积分电路18
3.5    微分电路19
4    积分电路的参数选取及仿真20
4.1   理想积分器20
4.1.1   理想积分器的参数选取20
4.1.2   理想积分器的频率特性21
4.2   带反馈电阻积分器23
4.2.1   带反馈电阻积分器的参数选取23
4.2.2   带反馈电阻积分器的频率特性23
4.3   电压串联型负反馈积分电路24
4.3.1   新型积分电路原理图24
4.3.2   积分器的零漂处理25
4.3.3  新型积分电路的 Simulink 仿真26 基于Matlab空心线圈积分电路设计+文献综述:http://www.751com.cn/tongxin/lunwen_6440.html
------分隔线----------------------------
推荐内容