毕业论文

打赏
当前位置: 毕业论文 > 电子通信 >

UWB超宽带通信系统信道的建模与分析

时间:2019-01-02 22:03来源:毕业论文
用了时域谱元法求得时域电场值,然后用CLEAN后处理算法进行信道参数提取来分析信道的特性。最后,对UWB室内传播信道进行了测量,并对所得的数据进行了分析

摘要超宽带通信系统是一种全新的通信系统,与传统无线通信系统相比,它有一些自身显著的特点:容量大、速率高、安全性高、成本少、功耗低。这些都成为UWB技术得以快速发展和应用的主要原因。超宽带无线信道是超宽带通信系统的一个重要部分,它的特性直接关系到通信系统通信质量的好坏。对无线信道的研究理论和方法,一般可分为三类:经验模型、信道实测和确定性模型。本文利用确定性建模的方法对信道进行仿真分析,主要用了时域谱元法求得时域电场值,然后用CLEAN后处理算法进行信道参数提取来分析信道的特性。最后,对UWB室内传播信道进行了测量,并对所得的数据进行了分析。32171
关键词  超宽带  通信系统  无线信道  时域谱元法
毕业论文设计说明书外文摘要
Title  Modeling and Analysis of UWB communication system channels                   
Abstract
Ultra-wideband communication system is a new communications system, compared with conventional wireless communication system, which has some of its notable features: high capacity, high speed, high security, low cost, low power consumption. These have become the UWB technology to the rapid development and application of the main reasons. Ultra-wideband wireless channel is an important part of ultra-wideband communication system, which is directly related to the characteristics of the communication system communication quality is good or bad. Radio channel theory and methods, and can be pided into three categories: the empirical model, channel measurements and deterministic models. In this paper, the method of deterministic channel modeling simulation analysis, the main use of the time-domain spectral element method to obtain the time domain electric field value, followed by the channel parameter extraction processing algorithm CLEAN After analyzing characteristics of the channel. Finally, we measured the propagation characteristics of UWB indoor channel,and the data obtained were analyzed.
Keywords Ultra-Wideband  Communication Systems  Radio channel  Time-domain spectral element method
目   次
1 引言 1
2 超宽带无线技术 3
2.1 超宽带无线技术概述 3
2.2 UWB技术特点 4
2.3无线信道基本理论 6
3时域谱元并行算法设计 10
3.1时域谱元并行算法的方案设计 10
3.2算例分析 11
4 UWB室内传播信道的测量和数据分析 13
4.1UWB无线信道建模13
4.2建立测量的程序13
4.3测量结果18
结论 22
致谢 23
参考文献24
1  引言
无线通信已经成为当前最火热的科学技术之一,应用于诸如如军工雷达、探测制导等。民用方面移动手机、广播电视等都与这门科技息息相关[1]。它的优点是特别方便,无需电缆的限制以及距离对其的限制。
无线信道建模方法可以分为统计建模和确定性建模[2]。统计建模方法可以广泛反映无线信道的传输特性。人们开始去更深入的研究确定性建模方法,研究各式各样复杂的尺寸大的无线信道的确定性建模。
现在社会的GSM,3G,4G移动通信可以实现地球上的任何两点之间基本上连通。而蓝牙,Zigbee,WLAN超宽带短距离无线通信技术也使得人们的生活更加方便。无线通信被广泛地应用于各个行业,包括军工,建筑,医疗等。UWB的概念在时域电磁学,表征某一类微波网络的瞬态行为。
在20世纪60年代末,脉冲测量技术开始应用开发,在60年代初通过调研到宽带天线元件的设计,引起了短脉冲雷达和通信系统的开发。到1989年,超宽带理论,技术和许多实施方法已经被开发用于广泛的应用,如雷达,通信,汽车防撞,定位系统,液位传感和高度测量。然而,远在外地的UWB前期工作发生在军事或机密计划内资金由美国政府。到了90年代末,UWB技术已经变得越来越商业化,它的发展已经大大加快了。 UWB超宽带通信系统信道的建模与分析:http://www.751com.cn/tongxin/lunwen_28628.html
------分隔线----------------------------
推荐内容