毕业论文

打赏
当前位置: 毕业论文 > 化学论文 >

PSt-b-P(St-alt-MA)-b-PAA双亲性嵌段共聚物的合成及性能

时间:2018-07-13 14:32来源:毕业论文
使用链转移剂三硫代碳酸二(a,a-二甲基-a-乙酸)酯(BDMAT),以苯乙烯(St)、马来酸酐(MA)、丙烯酸(AA)为合成单体,在引发剂偶氮二异丁氰(ABIN)作用下通过可逆加成—断裂转移

摘要本文使用链转移剂三硫代碳酸二(a,a-二甲基-a-乙酸)酯(BDMAT),以苯乙烯(St)、马来酸酐(MA)、丙烯酸(AA)为合成单体,在引发剂偶氮二异丁氰(ABIN)作用下通过可逆加成—断裂转移(RAFT)法合成双亲性嵌段共聚物苯乙烯-b-聚(苯乙烯/马来酸酐)-b-聚丙烯酸(PSt-b-PSMA-b-PAA),经红外光谱仪、液体核磁共振仪以及差示扫描量热仪进行表征。采用共溶剂透析法制备共聚物胶束,采用紫外可见分光光度计、激光纳米粒度及Zeta电位分析仪分析了不同条件对自组装行为的影响。结果表明,疏水嵌段所占比例越大,共聚物溶液初始浓度越高,聚合物的临界含水量越低。随着pH值的增大,胶束粒径变大。盐浓度增大,电荷屏蔽效应加强,净电荷减少,导致Zeta电位绝对值降低,胶束粒径增大。25756
关键词  可逆加成—断裂链转移聚合  自组装  胶束  双亲性嵌段共聚物  共溶剂透析法
毕业论文设计说明书外文摘要
Title  Synthesis and Properties of Amphiphilic Block Copolymers PSt-b-PSMA-b-PAA                                               
Abstract
In this article, Using the reverse addition-fragmentation chain transfer (RAFT) method ,The amphiphilic block copolymers(PSt-b-PSMA-b-PAA) were synthesized,with styrene (PS),maleic anhydride (MA), acrylic acid (AA) as the monomer,via the action of  the initiator(ABIN).The copolymer was characterized by FTIR,1HNMR and DSC. The copolymer micelles were prepared by dialyzing from the co-solvent. Analyzing the effects of different conditions on the self-assembly behavior by UV , Nano-ZS show that , the CWC of the copolymer becomes lower along with the larger proportion of the hydrophobic block and the higher initial concentration of the copolymer; With increasing pH, the micelle particle size becomes large; the increase of the salt concentration could also make the micelle particle size become large because of the reduction of the net charge in solution with lowing Zeta absolute values potential in the system.
Keyword  RAFT polymerization  Amphiphilic copolymer  Self-assembly  Micelle  Amphiphilic block copolymers  Co-solvent dialysis
目   次
1  绪论    1
1.1  双亲性嵌段共聚物概述    1
1.2  双亲性嵌段共聚物的合成方法    1
1.3  双亲性嵌段共聚物的大分子组装行为    3
1.4  双亲性嵌段共聚物的应用    6
1.5  本课题的主要研究内容    7
2  双亲性嵌段共聚物的合成与表征    9
2.1  引言    9
2.2  实验部分    9
2.3  结果与讨论    11
2.3.4  DSC分析    15
2.4  本章小结    15
3  大分子自组装行为研究    16
3.1  引言    16
3.2  实验部分    16
3.3  实验结果与讨论    17
3.4  本章小结    21
结  论    23
致  谢    23
参考文献25
1  绪论
1.1  双亲性嵌段共聚物概述
显而易见,双亲性嵌段共聚物是指高分子链段两端含有两种不同性质链的一类嵌段共聚物。这两种不同性质一般情况下是指“亲水”性和“亲油”性,由于两端性质的不同表现出不同的亲和性使得两亲性嵌段共聚物本身含有相分离特性[1]。通过控制反应物种类,反应条件以及不同的合成办法可以合成我们所需要的特定功能的嵌段共聚物。同时两亲性嵌段共聚物由于自身结构所表现出来的大分子组装行为可以在溶液中形成胶束。因此在生物化学电子学,医药学等方面[2]对其的研究也越来越受到关注。 PSt-b-P(St-alt-MA)-b-PAA双亲性嵌段共聚物的合成及性能:http://www.751com.cn/huaxue/lunwen_19689.html
------分隔线----------------------------
推荐内容