For measuring the subject, the measuring points are spread on inspection feature. At this time, the number of measuring points is determined first of all. It is the most influential factor of all the inspection variables to inspection resolution. If there is a lot of measuring points, inspection time increases. Generally, for reduction of the number of measuring points and the measuring time
Fig.4 The selection of inspection mode in OMM module
(a) Manual (b) General (c) Automatic Fig.5 The distribution of measuring point each mode
Fig.6 The procedures for determination of inspection parameters
about various inspection subjects, the number of measured points are as follows : 3~5 points for a straight line, 4~9 points for a plane, 5~9 points for a sphere, 6~12 points for a cylinder and 7~12 points for a cone. Because it is the minimum number of measuring points which can define the inspection feature about subject simply, it is the number of measuring points ruled out the repeatability of a machine or the size of an inspection
surface. Consequently, when the geometric tolerance is appraised or the result of inspection is represented using the minimum measuring points, it is not to be trusted. In this research, the repeatability of a machine tool and the size of inspection feature are added as a factor to decide the number of measuring points. Fig.7 shows the algorithm to determine the number of measuring points using Fuzzy logic. The minimum number of measuring points which is leaded by using Fuzzy logic agrees with the number of measuring points to evaluate the geometric tolerance. It is possible to input the maximum number of measuring points. The input variables are the area of
inspection feature, the resolution to lead the result of inspection and the repeatability of the machine tool.[9] The measuring points are altered actively by the value of input variables.
the values of s, t are larger than 0 and smaller than 1. This method is applied to the Automatic Mode. Fig.8 shows the inspection positions in case of 10 measuring points.
Table 1 Hammersley’s function for various features
252 288
Fig. 8 The distribution of ten Hammersley points on rectangular and circular surface
Fig. 7 The fuzzy logic for measuring points
3.2 Determination of the location of measuring points using Hammersley’s algorithm
The location of measuring points to be applied to
OMM module is determined by grid type and
3.3 Determination of the probe path using Traveling Salesperson Problem
In On-Machine Measurement, the path of probe must satisfy two conditions; generating the minimum moving distance and determining sequence of measuring
[10]
Hammersley’s algorithm. The grid type method which
points.
The guide point minimizes the measuring error
uses the equi-interval mesh pides the range of object into definite intervals for x-, y- directions. As this mesh is applied to object, the uniform grid is made in the range of inspection object and then the intersections of x-, y- axis are decided on the inspection positions. This method is applied to the General Mode. The method using Hammersley’s algorithm establishes (s, t) axis as Hammersley’s coordinate in object. If 2D-section is a rectangle, a rectangular coordinate is used. If 2D-section is a circle, a polar coordinate is used. Table.1 shows the Hammersley’s function for various features. In this table, 在线机器测量系统英文文献和中文翻译(3):http://www.751com.cn/fanyi/lunwen_80001.html